In the crane and industrial industry, the WRI® PS 620 rope is a general purpose 6 strand galvanized rope produced with a steel core, fully lubricated during manufacture produced in accordance with EN 12385. In underground mining, specially selected wire tensile grades and 6 strand construction enhance wear resistance. Specially formulated lubrication enhances wear properties, increases rope performance, and reduces environmental impact due to fly-off and the calibrated cut lengths and custom pad eyes simplify installation and reduce down-time. Excellent value for less demanding applications.

The Bridon Tiger Dyform® 6R is a high strength 6 strand rope on friction winders with reliable performance.

DyPac strand enhancement of a 34x7 (LCD) construction provides additional performance, an increase in strength of approximately 15%, reduced sheave and drum wear, and significantly enhanced drum spooling. As a result, operating depths can be extended up to approximately 6000 ft. (1830 m).

Bridon Tiger® 6R Bristar® is the most common used rope on friction winders with reliable performance, advanced diameter stability and lifetime with a Bristar® core.

Bridon Tiger® 6R is the most common used rope on friction winders with reliable performance.

Bridon Tiger® Superflex is a highly flexible rope with a flat strand construction. When it comes to a small loop diameter for a round balance rope, the Superflex ropes are the best choice.

The Bridon Tiger® 6T Compound Bristar® are the most commonly used rope construction for shaft hoisting. Excellent performance on ultra-deep drum winders and most robust rope on friction winders. Advanced diameter stability and lifetime with a Bristar® core.

WRI Power-Loc® FLC is most effective when installed with a D/d ratio greater than 100-1. Exclusive manufacturing techniques provide superior rotation resistance and virtually eliminate the natural torque and rotation common to round or flattened triangular strand ropes

Bekaert's Bridon Tiger® Half Lock Guide Ropes deliver high strength along with good resistance to wear and corrosion and reduced stretch.

A resilient 18x7 IWRC construction and wire tensile ranging from 1770 MPa (115 Long Tons/In2) to 2000 MPa(130 Long Tons/ In2) provide the necessary strength and reliability to operate up to depths of approximately 2000 ft.(610 m). A specialized Line Contact Design (LCD) improves performance and reduces internal cross cutting damage, common to other multi-strand products. By combining outer langs lay strands with inner regular lay strands, the underside of the outer strand wires run in the same direction as the wires of the supporting layer.